The way to go is to tweak your PC application to be more tolerant with timeouts dealing with larger pieces of data and perhaps buffering some packets. It can be used to enable a dial-up connection to a serial peripheral over the Internet. Silk wrote: I already found a solution with thread in place of the thread:- Are you positive that is really a solution if the original problem is really due to a thread security issue then it is likely that it was a racist condition and that it may well resursee in the future. I want to check the state of this sensor with for is command transparent mode serial communication Service. Based on what you say I think of the module since I should not go with such a small packet size but instead set up the package size and txto to maximize the number of bytes sent in a package. The way to go is to tweak the PC application to be more permissive with the timeouts handle larger data chunks and maybe do some packets buffering.It can be used to allow a remote connection to a serial peripheral over the Internet.Silke wrote: I already found a solution using threading instead of thread:- Are you positive that is really a solution If the original problem was truly because of a thread-safety issue then its most likely I think that it was a race condition and that it could very well re-appear in the future.I want check the state of this sensor with AT IS -command transparent mode serial communication service .Based on what you are saying I am thinking that on the module side I should not go with such a small packet size but instead set up the packet size and the txTo to maximize the number of bytes that get sent in a packet.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |